Wood science is the study of wood as a material that is renewable and of biological origin. Wood technology is now the way the tools are utilized in the processes of wood preservation. Wood is treated as a material in direct comparison with other products. The comparison made against other products will include the features of the material against those of wood, the value and the ease it can be worked on. The utilization of technology gives wood an upper hand in most of this comparison. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. Once a tree has been cut down another can be planted in the same spot. All the parts of wood can be put into use, and this makes it a better fit than other materials which most of their byproducts are a waste.
For your wooden products and house to stay for long and have a good appearance it needs to be protected. This protection is from moisture and insects which are the biggest threat to wood. The water particles in the timber increase the rotting and the insects bore through the wood. There are many ways timber is treated among them being the ACQ in other words alkaline copper Quaternary. The protection of from this chemical is based on copper. Although being a good method to use for wood protection it has presents some few challenges. It is a highly corrosive chemical that affects most metals that are used together with the wooden products. The concentration of the chemical that will be used to treat a piece of wood will depend on the where it is going to be used and the molecular structure of the wood. The concentration level of the chemical will be different for two pieces of wood where one is used above ground and the other close to a water body.
Many methods are being invented to protect the wood, and one of them is the copper metal method. This method is being accepted fast because is friendly to wooden fasteners. Micronized copper wood preservative is the correct term to refer this type of preservation. In this process microscopic particles of solid copper metal are mixed in a liquid carrier and injected to the wood at high pressure. The process eliminates the need to dissolve the copper as is done in earlier copper-based preservatives. This process is highly effective and the wood properties and heightened. The wood products protected using this method last longer.
Termites cannot eat through timber treated through this method. It has also shown to be an improvement in corrosion resistant properties to metal fasteners. The wood treated using this method last longer and is stronger.